80 Percent Lower
Every 80 percent lower we sell is proudly made in the U.S.A. from quality billet aluminum (6061-T6), mil-spec forged aluminum (7075-T6), or weapons-grade polymer.
What is an 80% Lower Receiver?
Officially called a “receiver blank” by the Bureau of Alcohol, Tobacco, and firearms (ATF), an 80% lower is an unfinished receiver that isn’t considered a firearm. Cutting and drilling the lower at home with hand tools turns it into a ready-to-build firearm by legal definition. Whether it’s an AR-15 80 lower, AR-10 80 lower, 1911 frame, or a polymer 80% pistol frame, thousands of shooters have built reliable and accurate rifles and pistols with our units.
Do 80% Lowers Require a License or FFL?
No. The Gun Control Act of 1968 says building a firearm for personal use without a license or paperwork is perfectly legal. The ATF also says 80% lowers are legal and aren’t considered firearms. So, you’re not subject to the same rules and restrictions when buying, shipping, owning, or building an 80 lower or other type of receiver blank.
- No background check required
- Ships directly to your front door
- No need to “register” an 80% lower
- Compatible with retail AR parts when complete
- No FFL/serialization required under federal law (state laws vary)
These same rules apply to all receiver blanks, frame blanks, and build kits we sell at 80-Lower.com. Some states have banned 80% lowers and certain firearm parts, or have otherwise restricted the sale and ownership of products we sell. So, be sure to check your local and state laws. We can’t ship our products to certain states. Please check our Shipping & Return Policy before placing an order (see restrictions).
How Do I Complete an 80% lower?
Completing a polymer or metal lower requires no experience and usually takes less than two hours. All you’ll need to get the job done is an 80% lower jig. All available jigs include the necessary instructions, tools, and bits. There are four steps required:
- Cut the cavity for the lower parts kit
- Drill the hammer pin hole
- Drill the trigger pin hole
- Drill the safety lever hole
Once you complete your lower, you can install a buffer assembly, lower parts kit, and pre-built upper receiver. Then you’re ready to hit the range! Completing an 80% frame for a Glock®-compatible handgun or 1911 is no different. Just drill the pin holes, cut the slide rails, and cut the barrel seat. The pistol jig instructions will tell you exactly what to do, and how. Order a build kit and purchase an 80% lower, and you can go from a bunch of parts to a functional AR rifle or pistol, 1911, or handgun in a single afternoon.
Execute the right to bear arms today. Your build awaits!
DISCLAIMER: If you are new to the world of DIY gun building, you likely have a lot of questions and rightfully so. It’s an area that has a lot of questions that, without the correct answers, could have some serious implications. At 80-lower.com, we are by no means providing this content on our website to serve as legal advice or legal counsel. We encourage each and every builder to perform their own research around their respective State laws as well as educating themselves on the Federal laws. When performing your own research, please be sure that you are getting your information from a reliable source.