80 Lowers with Jigs

80 Lowers with Jigs

Need help buying or building? Our FAQ page covers it all.

New to building your first AR from scratch? You may be familiar with 80% lowers and how this project works, but you might be unsure which jig and tools you need. We made it convenient to pick up everything you need to get started on your first 80% rifle or pistol build. Each 80% lower listed is paired with the right hardware.

What's Included

  • (1) 80% lower
  • (1) 80% jig
  • (1) Drill bit set
  • (1) End mill bit/set
  • Machining instructions

Additional Tools Required

The jig and lower kit will get you all the important parts required for your build. You'll need to provide some basic power tools -- like a drill press -- to work the jig and receiver. This guide covers the other tools required

How to Complete the Lower

Every 80% lower is different. Some are made from billet, some are forged, and others are made from weapons-grade polymer. Each jig is also different in appearance. The AR platform, however, is largely universal with heavily standardized parts comprising the receiver itself. That means that no matter the brand, caliber, or AR type (.308, 9mm, 300 Blackout, or 5.56 or .223), the fabrication required to made the receiver functional is all generally the same.  We wrote an in-depth instructional guide that shows how to complete an 80% lower receiver using a typical jig.

There are four steps to complete:

  1. Cut the cavity for the lower parts kit
  2. Drill the hammer pin hole
  3. Drill the trigger pin hole
  4. Drill the safety lever hole

This guide uses the Elite Builder Jig shown on this page paired with either billet or forged lowers. Armed with these tools, steps, and measurements, no experience is required for you to complete your first lower. 

Jig, Lower, and Parts Compatibility

The jig included with each combo kit is guaranteed to work with the included polymer, forged, or billet 80% lower. Most AR-15 jigs are universal, too. Unless otherwise stated, the AR-15, AR-10, or AR9 jig you receive with your kit will work with other 80% lowers of the same platform or caliber. The same rules apply for the drill bits and end mills you receive with your kit. All bits are made from high-speed steel or carbide, allowing you to easily complete multiple lowers.

Exercise your 2A rights. Start your build today.

DISCLAIMER: If you are new to the world of DIY gun building, you likely have a lot of questions and rightfully so. It’s an area that has a lot of questions that, without the correct answers, could have some serious implications. At 80-lower.com, we are by no means providing this content on our website to serve as legal advice or legal counsel. We encourage each and every builder to perform their own research around their respective State laws as well as educating themselves on the Federal laws. When performing your own research, please be sure that you are getting your information from a reliable source.

Compare Selected

We are a national retailer of individual components and not all products depicted on this website are legal in every state. Shipping of various products found on this website are prohibited to some states (such as California, Connecticut, District of Columbia, New Jersey, New York, Rhode Island, and Washington). The information, pictures, text or products presented on this website are not a representation by us, and should not be understood by you, that any product or completed firearm is legal to assemble or own in your state of residence. We encourage each and every builder to perform their own research about the state and federal laws that apply to them. It is your responsibility to understand the law and we encourage you to consult with an attorney or your local ATF representative.